Because of its simple structure and convenient use, the anti-collision wall formwork is mainly cast-in-place production mode in production, which can ensure the anti-collision wall dimension standard processed by the formwork, and the quality is qualified, and can be used as the protection of the highway. When using the formwork processing, it is mainly divided into four steps, which must be processed in a regular way, so as to make the anti-collision wall that meets the requirements.
1. The whole set of cement anti-collision wall formwork shall be inspected in advance, and some deformed or rusty moulds shall be cleaned to facilitate the application of release agent, so as to make the mould better used.
2. The cement anti-collision wall formwork is painted with oil and then poured with slurry. The mixing of cement is simpler than that of concrete, because there are not too many mixed materials. Other materials can be added properly according to the requirements for mixing. After the cement is poured into the mold, it is removed into the vibrator for treatment.
3. There will be some air holes on the surface after the air bubbles are discharged. You can use a scraper to smooth the surface of the produced anti-collision wall.
4. After the mud solidifies, disassemble the mold, first loosen the pull rod, then remove the bolts of the splicing mold, and then the mold can be disassembled normally. The disassembled mold should also be cleaned in time.